SELCO LECTRA CLEAN is a stabilized, fast acting
solvent blend, specially formulated for cleaning
and degreasing of electric motors and equipment.
Controlled evaporation and high Kauri Butanol
value provide strong solvent efficiency and
degreasing capabilities. Therefore it removes
very effectively oil, grease, wax, dirt, moisture
and foreign matter that cause current leakage
and electrical inefficiencies.
SELCO LECTRA CLEAN is ideal for use on all
high voltage equipment. It is non-conducting,
non-staining and non-corrosive. SELCO LECTRA
CLEAN does not contain Carbon Tetrachloride
or Petroleum Solvents. The use of SELCO LECTRA
CLEAN, in aerosol form saves time and money
because equipment can be cleaned in place"
and dismantling is not necessary.
TYPICAL APPLICATIONS
Electric motors, high voltage switch gear,
air conditioners, alarms, antenna insulators,
blowers, bus bars, cabinets, cables, chargers,
circuit breakers, coils, commutators, contacts
(110 V or above), conduits, controls, cross
bars, fans, fuse holders, fuses, gauges,
generators, housing, oscillators, portable
tools, pumps, regulators, relays, testers,
transformers, transmitters, welders.
DIRECTIONS
 |
Remove
cover plates for accessibility to equipment,
extremely heavy deposits should be prescribed
or wire brushed. With aerosol package
use the extension tube for hard to reach
areas. |
|
When cleaning
plastic or painted surfaces test a small
area before using. |
|
Apply SELCO
LECTRA CLEAN, liberally when spraying.
Allow excess to run off. |
|
When dipping,
agitation accelerates cleaning. Dip
tank should be covered when not in use. |
|
Air dry
or wipe with soft wiper. Forced air-dry
not recommended. |
|
Repeat
if necessary. |
Although SELCO LECTRA CLEAN is non-corrosive,
it is not a corrosion preventive. Therefore
protect and lubricate equipment afterwards
with SELCO LECTRA CLEAN.
SAFETY AND PRECAUTIONS
SELCO LECTRA CLEAN, is non-flammable. It is
non-staining and non-corrosive to metals.
Use with adequate ventilation and avoid prolonged
use in confined areas. Prevent splash-back
into eyes by use of glasses. Although occasional
skin contact is not harmful, the use of solvent-resistant
gloves is recommended.
PHYSICAL PROPERTIES OF SELCO LECTRA CLEAN
| Flash
Point |
Non-flammable |
| Distillation
Range |
76
- 122 ° C |
| Specific
Gravity (25 ° C.) |
1.38
+ 0.02 |
| Kauri-Butanol
Value |
120 |
| Dielectric
Strength |
28.000
V/cm |
| Dielectric
Constant |
7.2 |
|
|
