A
universal maintenance product for all electric
and electronic equipment: displaces and seals
out moisture,protects against corrosion and
oxidation and lubricates, penetrates and cleans,
at the same time.
SELCO 56 is a stable, inert organic formula,
especially prepared to prevent and repair
electrical failures due to moisture, corrosion,
dirt or friction. Its effectiveness is the
result of the following properties:
A very low surface tension, high capillary
action and strong affinity for metals, gives
it great penetrating and spreading powers
(expected coverage + 140 m2/liter). Therefore
the microscopic film will spread under any
moisture, covering the total surface by penetrating
into the finish pores and cracks. Penetration
continues for 24 hours, which is important
for complete moisture elimination. It will
at the same time release rusted and frozen
parts.
The continuous molecular film is self-repairing,
never becomes dry or brittle and seals the
surface against future moisture and corrosion.
The special corrosion protection properties
result from a multiple, complex system of
inhibitors dispersed in the non-volatile
part of the product. Insulating film resists
flow of corrosion current, passivating by
bonding to active metal surface ions, elimination
of electrolyte and corrosive media by film
barrier.
The volatile part of SELCO 56 offers cleaning
action as a supplementary benefit and will
evaporate after 4 - 6 hours. The lubricity
of the remaining film is excellent and offers
precision lubrication where it is required.
The high dielectric strength of SELCO 56
makes it ideal for high voltage applications.
It does not increase electrical resistance
but does restore electrical characteristics
to their original value. The time of protection
of SELCO 56 will vary with the environmental
conditions and the best results will be
obtained indoors. As it is a soft film that
never dries, direct weathering exposure
can limit the time of protection outdoors
and would require repeated application.
TYPICAL APPLICATIONS
Preventive maintenance program to increase
life expectancy of all electrical equipment
and to keep emergency equipment operational:
generators, pumps, etc. Eliminates breakdowns
due to poor environmental exposures, such
as flooding, high humidity, salt air, etc.
Stop leakage and arcing improves efficiency
due to restoration of original resistance
values. Corrosion protection of all electrical
equipment during storage and transport (removal
not necessary). Lubrication of contacts.
For use on air conditioners, alarms, battery
terminals and cables, blowers, bulb terminals,
bus bars, circuit breakers, coils conductors,
contacts, controls, elevators, filters, fuses,
gauges, generators, housing, ignitions, insulator,
bushings, instruments, meters, microphones,
motors, oscillators, PBX equipment, panel
boards, plugs, potentiometers, receivers,
relays, rheostats, signal systems, sockets,
solenoids, speakers, switches, and switch
gear, synchronizers, test equipment, terminal
blocks, terminal protectors, timers, tooling,
transformers, transmitters, tubes, welders,
and wire terminals.
PHYSICAL PROPERTIES OF SELCO - 56
| FLASH
POINT (OPEN CUP) |
80
° C |
| DISTILLATION
RANGE |
76-365
° C |
| FLASH
POINT DRY FILM (OPEN CUP) |
235
° C |
| HEAT
RESISTANCE DEGRADATION STARTS AT |
150
° C. |
| SPECIFIC
GRAVITY (20 ° C.) |
0.92
+/ -0.02 |
| DIELECTRIC
STRENGTH (ASTM D-877) |
31.500
V |
| AVERAGE
FILM THICKNESS |
1
TO 2 MICRONS |
| EXPECTED
COVERAGE |
100
- 140 M 2 /1 |
|
